Regulations, Standards and Project Guides
Featured articles from all topics. Use the filters below to narrow the full list.
Regulatory updates, testing and certification knowledge, and practical guidance on product compliance.
6 published articles
- Before EMC Testing: Power Supplies, Cables and Operating Modes
A different adapter, cable or operating mode can change the test configuration. Prepare a configuration sheet before sending the sample.
08.182026View details → - LVD, EMC or RED? Define the CE Scope from the Product Configuration
A 12 V input does not settle every safety question, and adding Bluetooth can change the compliance route. Start with power, intended use and radio functions.
08.172026View details → - Lithium-Battery Samples: Match Cell, Pack and Finished-Product Documents
Link the cell, battery pack, protection system, charger and finished-product models before arranging testing. Check that existing UN 38.3 evidence identifies the actual battery.
08.162026View details → - Verifying a Test Report or Certificate: Does It Cover This Product?
A matching document number is only the first check. Compare the issuer, model, configuration, standards and test scope with the product and the intended use.
08.152026View details → - Which Model Should You Send for Testing a Product Family?
The highest-power model is not automatically the worst case for every test. Map the differences before choosing safety, EMC and radio samples.
08.142026View details → - Before Report Issue: Match the Sample to the Technical-file Version
Connect the sample, drawings, BOM, firmware and test results through one configuration record. Keep changes visible when the production version differs.
08.132026View details →







